With this RIT_M Beta: V.1.06beta

A much more precise replication of the CVin at the CVout jack (when CV knob is fully down)
Before you go ahead:
Please note that this is a beta version! The previous version (V1.05) can be re-loaded.
This finer alignment feature is only accurate on the positive side. The neg. side is as before.
This beta does not affect any other workings of the RIT_M (i.e. quants, menus etc)


A special variation in the Calibration must be performed (unless you have aan accurate DMM) that will preserve the offset and gain settings:

Once the firmware has been updated:

-Unplug EVERYTHING from the RIT_M-

1) Turn CV knob fully CCW (down)

2) Press and hold the button for 10 seconds

3) Once Leds come on, press and hold button for about 1 second. The LEDs will begin to flash

4) Patch a jumper from CVin to CV out

5) Press button one more time

6) LED's will flash slowly, the faster, then very fast. Wait until the unit re-starts (about 1 minute)

You're done!

Have fun!! Sandy